Add Shape to your drives and control your game
Martin Chuck AND Danny Maude recently posted blogs in question trying to hit straight discs. You swing the golf club in an arc, so it’s almost impossible to get both the swing direction and the club face in the correct position for a consistent straight ride. Any imperfection will cause the ball to be thrown in the wrong direction, as well as adding a side hook or spin. You really should make slight adjustments to the settings to make sure the ball’s flight snaps or fades back into the target zone: fairway.
Both Martin AND Danny we have trained thousands of students to overcome swing problems so they realize that every golfer has their own unique swing problems. And of course you too.
Martin Chuck referred to his Automatic accuracy system. Basically, his system only works when you’re either CONSISTENT slut or slicer. Set up by queuing up to your destination and then compensate for the hook by slightly opening the club face to balance your hook. if you have cohesive piece, just close your club face according to different amounts to determine the ideal starting direction.
Danny describes solutions to moving the position slightly forward or backward along the target line to change the point where the swing arc reaches its lowest point to compensate for a consistent hook or cut. (You want to bottom out before hitting to run the discs on an uptrend.) Your next customization is this configuration with a slightly open club face to add a fade Or slightly closed face to add fig. Your goal is to curve the ball back into the fairway with each shot.
Small changes can fix swing issues. Tweak the settings to find the setup you want, then fine-tune it in your swing for more consistent rides. Write down your ideal settings and read them often. (Riding from a flat tee block is a key starting point for improving consistency.)
Practice with yours GOLFSTR+ to keep the forearm consistently straight and wrist action controlled. Buy one today to create 6 swing patches in www.GOLFSTR.com
The ability to add comments is not available.
